The TFP DPHU-110 is a high powered and versatile power-pack designed to meet the needs of modern mining equipment maintenance.

Available in single, dual or triple circuit configuration to allow movement of up to 3 actuators in one setup, such as excavator bucket changes

High quality components are carefully chosen and assembled under ISO 9001 QA. All TFP PowerPacks are Australian manufactured and supported. Operators manual are supplied and SOPs can be developed for specific tasks at additional cost.



  • Boom, arm and crowd movement for excavator or shovel bucket changes

  • Cordless pendant allows single operator to safely align bucket and cylinder pins

  • Walk undercarriage independently, or walk entire machine

  • Shovel or excavator slew system (for car body alignment)

  • Lift the attachment of an out of service machine

  • Pressurise the parking brake system for dump trucks and tracked machines (for the towing of broken down machines)

  • Shovel or excavator air-con system

  • Shovel or excavator grease system

  • Applicable to most hydraulic excavators and shovels

  • Cold weather package available

Installation kits to suit specific machines can be developed to suit customer needs



  • CAT C4.4 four cylinder water-cooled common rail diesel engine - 82kW (110HP)

  • Rexroth 83cc/rev variable displacement piston pump

  • Max flow of 185 litres/minute, Max pressure 280bar

  • 530 litre hydraulic oil tank with sight glass and low/high oil alarms and protection

  • 300 litre diesel tank with sight glass

  • 110% self-bunded

  • Hetronic cordless pendant control with integral dual ‘dead-man’ safety switches, 3 interlocked proportional controls, 2.4” TFT colour screen, separate emergency stop, shoulder strap, 2 batteries and Charger

  • Integral high pressure, high flow reel system with 5 dual reels (flow and return on the same reel)

  • Triple circuit with safety interlock and counter-balance, plus automatic travel brake release

  • Additional emergency stop on main unit

  • Electronic engine control with digital readout for safety and efficiency

  • Electronic proportional power control for maximum efficiency and precise movement control

  • Dual padlock type battery isolators for safe service and maintenance

  • Full-flow hydraulic filtration system to prevent contamination of host machine systems

  • Full-flow hydraulic cooling system to allow continuous operation at high load if required

  • Automatic brake control prevent un-expected movement of tracks or slew position

  • Dedicated case drain system (returns to powerpack) to prevent loss of oil level while walking. Also allows undercarriage to operate independent of upper assembly

  • 530 litre hydraulic tank allows for use on large cylinders, For example, 2 x 450mm diameter cylinders  could be extended 2 metres each without refill.

  • Low and high oil level alarms and switching prevent both the pump running dry and spills caused by accidental over-filling of the tank with return oil flow

  • Override on high oil level allows reduction of oil level through alternate circuit

  • Digital pressure readout on pendants allow operators to be aware of load levels

  • On screen warnings on pendant screen for safe and efficient operation

  • Max Pressure adjustable from cordless pendant

  • Large fuel tank allows for a full 12 hour shift operation without re-fuelling

  • Optional alternate remote control for continuous supply to suit hydraulic motor drive systems such as Air Con drive or Grease System

Installation kits to suit specific machines can be developed to suit customer needs